Influence of preheating and post-curing on a novel fiber-reinforced composite post material

• Autor(a) principal: ALMEIDA,Letícia Nunes de
• Data de Publicação: 2018
• Outros Autores: MENDES,Gustavo Adolfo Martins, FAVARÃO,Isabella Negro, KASUYA,Amanda Vessoni Barbosa, BORGES,Marcela Gonçalves, MENEZES,Murilo de Sousa, FONSECA,Rodrigo Borges
• Tipo de documento: Artigo
• Idioma: eng
• Título da fonte: Brazilian Oral Research
• Texto Completo: http://old.scielo.br/scielo.php?script=sci_arttext&pid=S1806-83242018000100289
• topic: Casts; Surgical

Abstract The aim of this study was to investigate the influence of preheating and post-curing methods on diametral tensile strength (DTS), flexural strength (FS), knoop microhardness (KHN), and degree of conversion (DC) of an experimental fiber-reinforced composite (FRC). Specimens (30 wt% of 3-mm-short E-glass fiber, 22.5 wt% of methacrylated-based resin and 47.5 wt% of filler particles) were subjected to: P – photocuring at 1500 mW/cm2 for 40 s (control); P/M – photocuring and microwave post-curing (540W/5 minutes); P/A – photocuring and autoclave post-curing (120°C/15 minutes); PH-P – preheating (60°C) and photocuring; PH-P/M – preheating, photocuring and microwave post-curing; and PH-P/A – preheating, photocuring and autoclave post-curing. Specimens for DTS (Ø 3 x 6 mm) and FS (25 x 2 x 2 mm) were tested at Instron 5965. KHN employed a 50g load for 30s. DC was measured using FTIR spectroscopy. Statistical analysis employed: factorial analysis, normality test, one-way ANOVA and Tukey’s HSD test, independent T-test and the Dunnett test. Interaction between factors was not significant (P>0.05). Preheating promoted significantly higher values of FS and KHN (p = 0.0001). Post-curing promoted significantly higher values for KHN (p = 0.0001). For DTS (p = 0.066) and DC (p= 0.724) no statistical difference was found between groups. SEM images showed that preheating promoted better interaction between glass fibers and resin matrix. Preheating increased FS, KHN and DTS, and post-curing increased KHN. DC was not affected by both methods. Preheating and post-curing methods can be used to improve some mechanical properties of FRCs’ but degree of conversion remains unaffected.