Evaluation of Sample Preparation Procedures for Determination of Cr(VI) in Cr2O3 Pigments by Vis Spectrophotometry

• Autor(a) principal: Santos,Eder José dos
• Data de Publicação: 2021
• Outros Autores: Sabatke,Mateus, Herrmann,Amanda Beatriz, Sturgeon,Ralph Edward
• Tipo de documento: Artigo
• Idioma: eng
• Título da fonte: Brazilian Archives of Biology and Technology
• Texto Completo: http://old.scielo.br/scielo.php?script=sci_arttext&pid=S1516-89132021000200203
• topic: Cr2O3; pigments; Cr(VI); Vis spectrophotometry

Abstract Six sample preparation procedures were evaluated for selective extraction of Cr(VI) from commercial samples of chromium oxide green (Cr2O3) pigments prior to formation of its diphenylcarbazone complex [CrDPCO]- for determination by visible spectrophotometry: (I) water-soluble chromium; (II) EPA method 3060A without Mg2+; (III) EPA method 3060A with Mg2+; (IV) Na3PO4 based extraction; (V) method IRSA16 based on acidic extraction and; (VI) Na2CO3 based extraction. Evaluation of the influence of concomitant Cr(III) ions, time and stability of the [CrDPCO]- complex was investigated. Recoveries of soluble and insoluble Cr(VI) species were 86% and 80%, respectively, using procedure (VI). Direct calibration against aqueous standards prepared in the extraction medium was successful for Cr(VI) in the concentration range 0.05-1.50 μg L-1. Limits of detection and quantitation were 0.3 µg g-1 and 1.0 µg g-1, respectively, for 250 mg subsamples/25 mL. Procedure (VI) was applied to the analysis of four commercial samples of Cr2O3 pigments, three determined to have Cr(VI) within compliance limits below 1.0 µg g-1, but one at 16.6 ± 0.6 µg g-1, prohibiting use of this pigment in cosmetic formulations. This sample was conveniently employed to evaluate the accuracy of the method. The recommended procedure is simple and accurate and has been adopted by Tecpar’s laboratory of Parana Institute of Technology (Curitiba, Brazil).