Caracterização do bambu laminado colado como alternativa tecnológica industrial

• Autor(a) principal: Rosa, Rafael Amorim
• Data de Publicação: 2013
• Tipo de documento: Dissertação
• Idioma: por
• Título da fonte: Repositório Institucional da Universidade Federal do Espírito Santo (riUfes)
• Texto Completo: http://repositorio.ufes.br/handle/10/5790
• topic: Glued bamboo lumber; Dendrocalamus giganteus; Bambusa vlugaris; Adhesives; Non-destructive methods; Preservative treatments; Bambu laminado colado; Dendrocalamus giganteus; Bambusa Vulgaris; Adesivos; Métodos não destrutivos; Tratamentos preservativos; Recursos Florestais e Engenharia Florestal; Bambú - Aspectos econômicos; Indústria madeireira; 630

This study aimed to verify the technological properties of the Dendrocalamus giganteus and Bambusa vulgaris bamboo; evaluate the physical and mechanical properties of glued laminated bamboo (BLC) according to the species, the adhesives and the preservant treatments; correlate both the module break and the modulus of elasticity - MOE of BLCs obtained by means of nondestructive methods with destructive method.. For this, were produced bamboo slivers with dimensions 0,5 x 3,0 x 70,0 cm (thickness, width and lenght) with B.vulgaris and D. giganteus species over three years old. One of these bamboo slivers were immersed in water and the other part in Timbor, lasting 15 days for both treatments. The adhesives used were based emulsion polymer isocyanate (EPI), melamine urea formaldehyde (MUF); cross polyvinyl acetate (PVAc) and resorcinol formaldehyde (RF). The non-destructive methods were used Stress Wave (SW), longitudinal vibration (vib. long.) and transverse vibration (vib. trans.). It was observed that the BLCs made from B. vulgaris demonstrated greater dimensional instability than those produced with the D. giganteus. However, MUF adhesive and RF conferred greater dimensional stability for the BLCs produced with both species. Both BLCs D. giganteus and B. vulgaris in relation to the two treatments had the lowest average failure in bamboo bonded with EPI and PVA. For BLCs produced from D. giganteus bamboo, the Stress Wave method proved not to be suitable for estimating the elastic modulus to BLCs adhered with EPI, MUF, PVA and RF. The vib. Long. and vib. trans. Methods demonstrated good possibility of estimating the MOE for BLCs of D. giganteus for any adhesive. For non-destructive methods performed with BLCs B. vulgaris bamboo, Stress Wave technique proved to be suitable for the BLCs bonded with MUF and PVA. In the vib. Long. Method, the BLCs made from B. vulgaris and bonded with MUF, PVA and RF had high estimation error. Already vib.trans.method provided high coefficient of Pearson correlation (R²), proving to be the most recommended. The vib.trans.method proved to be the best in the estimation of the modulus of elasticity for both BLCs made from D. giganteus and B. vulgaris, providing the smallest errors and the highest R². According to the physical and mechanical results obtained, it can be affirmed that BLCs made with both the species of D. giganteus or B. vulgaris may be employed for the furniture production