Experimental characterization and modeling of the plastic behavior of a third­generation advanced high strength steel sheet

• Autor(a) principal: Santos, Rafael Oliveira
• Data de Publicação: 2022
• Tipo de documento: Tese
• Idioma: por
• Título da fonte: Repositório Institucional da Universidade Federal Fluminense (RIUFF)
• Texto Completo: http://app.uff.br/riuff/handle/1/27170
• topic: Advanced high strength steels; 980 class; Mechanical testing; Limit strains; Damage modeling; Sheet metal forming; Chapa de aço; Comportamento plástico; Engenharia Metalúrgica; Produção intelectual; Aços avançados de alta resistência; Classe 980; Ensaios mecânicos; Deformações limites; Modelamento de dano; Conformação de chapas

The third generation of the advanced high­strength steels (AHSS) has attracted the automotive industry attention owing to its good compromise between the formability and production cost. The current development stage of these steels so far has few products available on the market, as well as little research aimed at studying their formability. With an ultimate tensile strength greater than 1000 MPa and total elongation above 20%, the third­generation AHSS with 980 MPa grade was the first sheet of this class of steel to be commercialized. In this work, several mechanical tests were performed to analyze the plastic behavior of a cold­rolled Gen3 980T steel with a nominal thickness of 1.58 mm. The mechanical properties and the plastic anisotropy Lankford coefficients were obtained from uniaxial tensile tests performed in 7 angular orientations in the plane of the sheet. The work­hardening of the Gen3 980T steel sheet was also assessed by means of the hydraulic bulge test, and the biaxial anisotropy coefficient was obtained using the disc compression test. The formability was investigated by means of the hole expansion, Erichsen cupping, and forming limit curve (FLC) test procedures. The limit strains were defined by ISO 12004­2 standard from in­plane tests (uniaxial tension and plane strain in tension) and out of plane hemispherical­punching tests (Nakajima procedure). The Gurson­Tvergaard­Needleman (GTN) damage model was adopted to describe the fracture behavior of the Gen3 980T steel. A simple methodology for identifying the parameters of the GTN model was proposed. This calibration procedure was validated by comparing finite element predictions with the experimental measurements obtained from the mechanical tests. The Gen3 980T steel has a microstructure composed of martensite, ferrite, and retained austenite. In the as­received condition, the X­ray diffraction analysis provided 12.2% of the retained austenite volume fraction. In the sheet rolling direction, the average values of the yield stress () and ultimate tensile strength () are equal to 604 and 1040 MPa, respectively, along with a total elongation ( ) of 23.4%. In this way, Gen3 980T steel has global formability, defined by = 24.3 GPa%, a value which is consistent with that expected for the third­generation of advanced high­strength steels. The Lankford coefficients determined in the angular orientations 0, 45, and 90 degrees with respect to the rolling direction are very close, which provided planar and normal anisotropy coefficients of − 0,079 and 0.917, respectively. The hole expansion ratio (HER) determined for the Gen3 980T steel sheet was equal to 10.9%, whereas the corresponding average Erichsen cupping test index (EI) was equal to 10.62 mm. The numerical simulations were able to describe the increase in formability due to the reduction of the friction coefficient and the effects inherent to the Nakajima test sample's curvature. The GTN damage model parameters, identified from the experimental uniaxial tensile data, provided a good forecast of the experimental results located on the left­hand side of the FLC. Regarding the right side of the FLC, the results obtained for the limit strains were conservative, mainly for the equal biaxial stretching.