A novel route to optimize placement equipment kinematics by coupling capacitive accelerometers

• Autor(a) principal: Veiga, João
• Data de Publicação: 2022
• Outros Autores: Lima, Susana, Silva, Luís Carlos Castro, Carneiro, Vítor Hugo, Pinhão, Mário, Gonçalves, A. Manuela, Malheiro, M. Teresa, Sampaio, Álvaro M., Meireles, José, Pontes, A. J., Machado, José
• Tipo de documento: Artigo
• Idioma: eng
• Título da fonte: Repositório Científico de Acesso Aberto de Portugal (Repositórios Cientìficos)
• Texto Completo: https://hdl.handle.net/1822/80664
• topic: accelerometers; planar motion; surface mount device; deployment optimization; Ciências Naturais::Matemáticas; Engenharia e Tecnologia::Engenharia dos Materiais; Science & Technology

Machine end-effector kinematic analysis is critical to optimizing transporting components where inertial forces are the main loads. While displacements may be measured with relatively high accuracy in transportation equipment motors, the inertial forces in the transported components are seldom optimized. This is especially relevant in electronic component placement systems, where the components have a wide range of configurations (i.e., geometry and mass) and the deployment dimensional/geometric tolerances are remarkably good. The optimization of these systems requires the monitoring of the real position of the accelerometers relative to the measurement point of interest with sufficient accuracy that allows the assembly position to be predicted instantaneously. This study shows a novel method to calibrate this equipment using triaxial accelerometers on a surface mount machine to measure the end-effector accelerations and velocities in its planar motion. The dynamic equations of the system and the method for integration are presented to address the uncertainty on the exact position of the accelerometer sensors relative to the measuring point of interest exist and allow the position correction to optimize response and accuracy.