Análise dos métodos de cálculo de golpe de ariete em tubulações

• Autor(a) principal: Nascimento, Thales Alves [UNESP]
• Data de Publicação: 2015
• Tipo de documento: Trabalho de conclusão de curso
• Idioma: por
• Título da fonte: Repositório Institucional da UNESP
• Texto Completo: http://hdl.handle.net/11449/123091; http://www.athena.biblioteca.unesp.br/exlibris/bd/capelo/2015-05-06/000823599.pdf
• topic: Golpe de ariete; Engenharia hidraulica; Tubulações; Water hammer

This work studies the most commonly used methods and make comparisons and discussions of the findings made by each of them and the results provided by them. The objective of this research was to show that the method of characteristics is currently the most efficient method to perform these simulations because of its broad scope low simplifications, requirement allowing to consider every detail of the pipe and fluid. Manual calculations are performed and also a software capable of calculating this phenomenon for various situations, such as water pump, elevated tanks, valves and quick maneuver was developed. The software is based on the method of characteristics that is currently recommended by ABNT. These methods, and the results are obtained numerically and graphically are adopted pipes and amount of downstream conditions and in which will be applied. The conclusions reached showed that the Allievi method is widely used yet because of its efficiency and quick calculation for simple pipes. The method of characteristics, although a lot of work to be calculated due to the calculation is iterative process and requires a program to use it, is the only one that allows the calculation with all amount to the conditions situations and downstream of all the pipe possibilities found